The Signal Out Profiles dialog allows creating and managing different profiles for controlling the camera's signal outputs. The profiles thus created are used in the detail view of the Action Group Overview dialog to execute the Signal Out action.
Note: This feature is not available for Web and Basic models.
|Profile name||Enter a unique profile name.|
|Delete||To delete a stored profile, click on Delete and confirm your selection by clicking on the Set button.|
|Signal Output Duration||Switches the signal output to high for the desired duration.
Value range: 1 second .. 5 minutes
|Signal Output Pin||Select a signal output pin for this profile.|
The available signal output pins are depending on the camera model and the attached hardware expansions (see Manage Hardware Expansions).
|Signal Output Mode||State of the signal output pin on alarm. The initial value on camera start is the opposite state.|
Click on Add new profile at the bottom of the dialog to create a new signal output profile.
Click on the Set button to activate your settings and to save them until the next reboot of the camera.
Click on the Factory button to load the factory defaults for this dialog (this button may not be present in all dialogs).
Click on the Restore button to undo your most recent changes that have not been stored in the camera permanently.
Click on the Close button to close the dialog. While closing the dialog, the system checks the entire configuration for changes. If changes are detected, you will be asked if you would like to store the entire configuration permanently.