Open the Message Profiles for Action Groups dialog to configure the messages that are sent upon specific actions.
Open the Action Group Overview dialog and edit an action group to link its actions to specific events.
Enter the desired MxMessageSystem Name for each message profile. A valid MxMessageSystem-Name must start with a letter, it must not contain spaces, tabs or the characters "
%" or "
.", the name is case-sensitive and the maximum length is 31 characters. Note that you can create several profiles with the same MxMessageSystem name.
Using the JSON-based API of the camera, you can see the current messages of the MxMessageSystem. Enter the following URL on your camera in a browser:
Click on the Set button to activate your settings and to save them until the next reboot of the camera.
Click on the Factory button to load the factory defaults for this dialog (this button may not be present in all dialogs).
Click on the Restore button to undo your most recent changes that have not been stored in the camera permanently.
Click on the Close button to close the dialog. While closing the dialog, the system checks the entire configuration for changes. If changes are detected, you will be asked if you would like to store the entire configuration permanently.